Fanuc Power Mate i-D/H Operator Manual

10. CREATING PROGRAMS
B–63174EN/03
OPERATION
500
In the TEACH IN JOG/HANDLE mode or TEACH IN STEP /
HANDLE mode, a machine position along the X, Y, and Z axes obtained
by manual operation is stored in memory as a program position to create
a program.
The words other than X, Y, and Z, which include O, N, G, R, F, C, M,
S, T, P, Q, and EOB, can be stored in memory in the same way as in EDIT
mode.
Procedure for Creating Programs in TEACH IN Mode
The procedure described below can be used to store a machine position
along the
X, and Y axes.
1 Select the
TEACH IN JOG/HANDLE mode or TEACH IN STEP/
HANDLE mode.
2 Move the tool to the desired position with jog, step or handle feed.
3 Press
PROG
key to display the program screen. Search for or register
the number of a program to be edited and move the cursor to the
position where the machine position along each axis is to be
registered (inserted).
4 Key in address
X
.
5 Press the
INSERT
key. Then a machine position along the X axis is
stored in memory.
(Example)
X10.521 Absolute positon (for mm input)
X10521 Data stored in memory
6 Similarly, key in
Y
, then press the
INSERT
key. Then a machine
position along the Y axis is stored in memory.
All coordinates stored using this method are absolute coordinates.
10.3
CREATING
PROGRAMS IN
TEACH IN MODE
Procedure for CRT/MDI

Leave a Reply

Your email address will not be published. Required fields are marked *