Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
10. CREATING PROGRAMS
OPERATION
501
O1234 ;
N1 G92 X10000 Y0 ;
N2 G00 G90 X3025 Y23723 ;
N3 G01 X0 Y10000 F300 ;
N4 M02 ;
X
Y
P1
(3025, 23723)
P2 (0, 10000)
P0 (10000, 0)
1 Set the setting data SEQUENCE NO. to 1 (on). (The incremental
value parameter (No.3216) is assumed to be “1”.)
2 Select the
TEACH IN STEP/HANDLE mode.
3 Make positioning at position
P0 by the manual pulse generator.
4 Select the program screen.
5 Enter program number O1234 as follows:
O
1
2 3
4
INSERT
This operation registers program number O1234 in memory.
Next, press the following keys:
EOB
INSERT
An EOB (;) is entered after program number O1234. Because no
number is specified after N, sequence numbers are automatically
inserted for N0 and the first block (N1) is registered in memory.
6 Enter the
P0 machine position for data of the first block as follows:
G 9 2
INSERT
X
INSERT
Y
INSERT
EOB
INSERT
This operation registers G92X10000Y0; in memory. The automatic
sequence number insertion function registers N2 of the second block
in memory.
7 Position the tool at
P1 with the manual pulse generator.
8 Enter the
P1 machine position for data of the second block as follows:
G
0 0
INSERT
G 9
0
X
INSERT
Y
INSERT
EOB
INSERT
This operation registers G00G90X3025Y23723; in memory. The
automatic sequence number insertion function registers N3 of the
third block in memory.
9 Position the tool at
P2 with the manual pulse generator.
Examples for CRT/MDI

Leave a Reply

Your email address will not be published. Required fields are marked *