Fanuc Power Mate i-D/H Operator Manual

11. SETTING AND DISPLAYING DATA
B–63174EN/03
OPERATION
516
[][][][][]ABS REL ALL HNDL (OPRT)
AUTO **** *** *** 19:35:12 PATH 1
ACTUAL POSITION(RELATIVE) O1000 N00000
PART COUNT 15
RUN TIME 0H13M CYCLE TIME 0H 0M 0S
ACT.F 0 MM/M
X
1
0.000
Y
2
0.000
(PARAMETER 3108#0=1)
(Position display includes the
position of another path”.)
1 Press the
PRGRM
key.
Program screen.
<O0001>N010 90
G01 G43 X10 ;
The place on the editing now is shown by < >.
The place on execution now is shown by >.
The current position of the tool in the relative coordinate system can be
reset to 0 or preset to a specified value as follows:
Procedure to Set the Axis Coordinate to a Specified Value
1 Enter an axis address (such as X or Y) on the screen for the relative
coordinates. The indication for the specified axis blinks and the soft
keys change as shown on the left.
2 To reset the coordinate to 0, press soft key
[ORGIN]. The relative
coordinate for the blinking axis is reset to 0.
To preset the coordinate to a specified value, enter the value and
press soft key [PRESET]. The relative coordinate for the blinking
axis is set to the entered value.
Procedure for DPL/MDI
Explanations
Setting the relative
coordinates
Procedure for CRT/MDI
ORIGIN
2 4 6. 9 1 2
Y 9 1 3. 7 8 0
>X
AUTO
PRESET
X

Leave a Reply

Your email address will not be published. Required fields are marked *