Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
11. SETTING AND DISPLAYING DATA
OPERATION
519
(RELATIVE)
X1 0.000
Y2 0.000
(ABSOLUTE)
X1 0.000
Y2 0.000
(MACHINE)
X1 1282.107
Y2 1028.259
(DISTANCE TO GO)
X1 0.000
Y2 0.000
AUTO **** *** *** 19:36:57 PATH 1
ACTUAL POSITION O1000 N00000
PART COUNT 15
RUN TIME 0H13M CYCLE TIME 0H 0M 0S
ACT.F 0 MM/M
[][][][][]ABS REL ALL HNDL (OPRT)
(PARAMETER 3108#0=1)
(”Position display includes the
position of another path”.)
The current positions of the tool in the following coordinate systems are
displayed at the same time:
Current position in the relative coordinate system
(relative coordinate)
Current position in the work coordinate system
(work coordinate)
Current position in the machine coordinate system
(machine coordinate)
Distance to go (distance to go)
The distance remaining is displayed in the AUTO or MDI mode. The
distance the tool is yet to be moved in the current block is displayed.
The least command increment is used as the unit for values displayed in
the machine coordinate system. However, the least input increment can
be used by setting bit 0 (MCN) of parameter No. 3104.
On the overall position display screen, relative coordinates can be reset
to 0 or preset to specified values. Use the same procedure used to reset
relative coordinates (V–11.1.2).
When there are five or more controlled axes, press the
[ALL] soft key to
display alternately absolute and relative coordinates.
Explanations
Coordinate display
Distance to go
Machine coordinate
system
Resetting relative
coordinates
Displaying the fifth and
subsequent axes
(Powet Mate i–H)

Leave a Reply

Your email address will not be published. Required fields are marked *