Fanuc Power Mate i-D/H Operator Manual

11. SETTING AND DISPLAYING DATA
B–63174EN/03
OPERATION
522
This section describes the screens displayed by pressing function key
PROG
in AUTO or MDI mode. The following screens display the
execution state for the program currently being executed.
1. Program contents display screen
2. Current block display screen
3. Next block display screen
4. Program check screen
5. Program screen for MDI operation
Displays the program currently being executed in AUTO or MDI mode.
Displaying the Program Contents
1 Press function key
PROG
to display a program display screen.
2 Press chapter selection soft key [PRGRM].
The cursor is positioned at the block currently being executed.
O2000 ;
N100 G92 X0 Y0 Z70. ;
N110 G91 G00 Y–70. ;
N120 Y–50. ;
N130 G03 X17.5 Y17.5 R17.5 ;
N140 G01 X–25. ;
N150 X27.5 Y27.5 R27.5 ;
N160 G01 X20. ;
N170 X45. Y45. R45 ;
> _
AUTO STRT *** 16:05:59
PROGRAM O2000 N00130
[][][][][]PRGRM CHECK CURRNT NEXT (OPRT)
11.2
SCREENS
DISPLAYED BY
FUNCTION KEY
<prog>
(IN AUTO MODE OR
MDI MODE)
PROG
11.2.1
Program Contents
Display
Procedure for CRT/MDI

Leave a Reply

Your email address will not be published. Required fields are marked *