Fanuc Power Mate i-D/H Operator Manual

11. SETTING AND DISPLAYING DATA
B–63174EN/03
OPERATION
526
O0010;
G92 G00 X100. ;
G00 X0 ;
G01 X100. F1000 ;
(ABSOLUTE) (DIST TO GO) G00 G21 G67X1
0.000 X 0.000 G17 G49 G64
Y2 0.000 Y 0.000 G90 G80
G94 G98
HM
T
FS
> _
AUTO **** *** *** 20:50:04 PATH 1
PROGRAM CHECK O0010 N00010
(PARAMETER 3108#0=1)
(Position display includes the
position of another path”.)
[][][][][]ABS REL (OPRT)
For the program currently being executed, the block currently being
executed is displayed first. The block currently being executed is
displayed in reverse video.
The position in the workpiece coordinate system or relative coordinate
system and the remaining distance are displayed. The absolute positions
and relative positions are switched by soft keys
[ABS] and [REL].
When there are six or more controlled axes, pressing the [ABS] or [REL]
soft key toggles the display between the absolute coordinates for the first
to fifth axes and those for the sixth to eighth axes.
Up to 12 modal G codes are displayed.
During automatic operation, the actual speed, SACT, and repeat count are
displayed. The key input prompt (>_) is displayed otherwise.
Then bit 2 (PCT) of parameter No.3108 is set to 1, the T codes specified
with the PMC (HD.T/NX.T) are displayed instead of those specified in
the program. Refer to the FANUC PMC Programming Manual
(B–61863E) for details of HD.T/NX.T.
Explanations
Program display
Current position display
Modal G codes
Display during automatic
operation
T codes

Leave a Reply

Your email address will not be published. Required fields are marked *