Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
11. SETTING AND DISPLAYING DATA
OPERATION
527
Displays the program input from the MDI and modal data in the MDI
mode.
Displaying the Program Screen for MDI Operation
1 Press function key
PROG
.
2 Press chapter selection soft key
[MDI].
The program input from the MDI and modal data are displayed.
O0000 G00 X100.0 Z200.0 ;
M03 ;
G01 Z120.0 F500 ;
M98 P9010 ;
G00 Z0.0 ;
G00 G90 G94 G80
G17 G21 G49 G67
H M
T S
F
> _ S 0 T0000
MDI **** *** *** 16:05:59
PROGRAM (MDI) O2000 N00130
Program
Modal information
[][][][][]PRGRM MDI CURRNT NEXT (OPRT)
See V–4.2 for MDI operation.
The modal data is displayed when bit 7 (MDL) of parameter No. 3107 is
set to 1. Up to 16 modal G codes are displayed.
During automatic operation, the actual speed, SACT, and repeat count are
displayed.
The key input prompt (>_) is displayed otherwise.
11.2.5
Program Screen for
MDI Operation
Procedure for CRT/MDI
Explanations
MDI operation
Modal information
Displaying during
automatic operation

Leave a Reply

Your email address will not be published. Required fields are marked *