Fanuc Power Mate i-D/H Operator Manual

11. SETTING AND DISPLAYING DATA
B–63174EN/03
OPERATION
528
This section describes the screens displayed by pressing function key
PROG
in the EDIT mode. Function key
PROG
in the EDIT mode can
display the program editing screen and the program screen (displays
memory used and a list of programs). Pressing function key
PROG
in the
EDIT mode can also display the floppy file directory screen. See V–9 for
the program editing screen. See V–8 for the floppy file directory screen.
Displays the number of registered programs, memory used, and a list of
registered programs.
Displaying Memory Used and a List of Programs
1 Select the EDIT mode.
2 Press function key
PROG
.
3 Press chapter selection soft key
[DIR].
PROGRAM (NUM.) MEMORY (CHAR.)
USED: 60 3321
FREE: 2 429
O0010 O0001 O0003 O0002 O0555 O0999
O0062 O0004 O0005 O1111 O0969 O6666
O0021 O1234 O0588 O0020 O0040
> _ S 0 T0000
MDI **** *** *** 16:05:59
PROGRAM DIRECTORY O0001 N00010
[][][][][]PRGRM DIR C.A.P. (OPRT)
PROGRAM NO. USED
PROGRAM NO. USED : The number of the programs registered
(including the subprograms)
FREE : The number of programs which can be
registered additionally.
MEMORY AREA USED
MEMORY AREA USED : The capacity of the program memory in which
data is registered (indicated by the number of
characters).
FREE : The capacity of the program memory which
can be used additionally (indicated by the
number of characters).
11.3
SCREENS
DISPLAYED BY
FUNCTION KEY
<prog>
(IN THE EDIT MODE)
PROG
11.3.1
Displaying Memory
Used and a List
of Programs
Procedure for CRT/MDI
Explanations
Details of memory used

Leave a Reply

Your email address will not be published. Required fields are marked *