Fanuc Power Mate i-D/H Operator Manual

11. SETTING AND DISPLAYING DATA
B–63174EN/03
OPERATION
530
Always enter a program name between the control out and control in
codes immediately after the program number.
Up to 31 characters can be used for naming a program within the
parentheses. If 31 characters are exceeded, the exceeded characters are
not displayed.
Only program number is displayed for the program without any program
name.
(∆∆∆∆…∆) 
;
Program number
Program name (up to 31 characters)
Programs are displayed in the same order that they are registered in the
program library list. However, if bit 4 (SOR) of parameter No. 3107 is
set to 1, programs are displayed in the order of program number starting
from the smallest one.
When no program has been deleted from the list, each program is
registered at the end of the list.
If some programs in the list were deleted, then a new program is
registered, the new program is inserted in the empty location in the list
created by the deleted programs.
Example) When bit 4 (SOR) of parameter No. 3107 is 0
1. After clearing all programs, register programs O0001, O0002,
O0003, O0004, and O0005 in this order. The program library list
displays the programs in the following order:
O0001, O0002, O0003, O0004, O0005
2. Delete O0002 and O0004. The program library list displays the
programs in the following order:
O0001, O0003, O0005
3. Register O0009. The program library list displays the programs
in the following order:
O0001, O0009, O0003, O0005
Program name
Order in which programs
are displayed in the
program library list
Order in which programs
are registered

Leave a Reply

Your email address will not be published. Required fields are marked *