Fanuc Power Mate i-D/H Operator Manual

11. SETTING AND DISPLAYING DATA
B–63174EN/03
OPERATION
532
Tool length offset values are specified by H codes in a program.
Compensation values corresponding to H codes are displayed or set on the
screen.
Setting and Displaying the Tool Length Compensation Value
1 Press function key
OFFSET
SETTING
.
For the Power Mate i–D2, select the tool post for which tool
compensation valuse are to be displayed with the tool post selection
switch or MDI key board.
2 Press chapter selection soft key [OFFSET] or press
OFFSET
SETTING
several
times until the machine compensation screen is displayed.
OFFSET O0001 N00000
NO. DATA NO. DATA
001 1.000 009 0.000
002 –2.000 010 –7.500
003 0.000 011 12.000
004 5.000 012 –20.000
005 0.000 013 0.000
006 0.000 014 0.000
007 0.000 015 0.000
008 0.000 016 0.000
ACTUAL POSITION (RELATIVE)
X 0.000 Y 0.000
> _
MDI **** *** *** 16:05:59
[][][][][]OFFSET SETING WORK (OPRT)
3 Move the cursor to the compensation value to be set or changed using
page keys and cursor keys, or enter the compensation number for the
compensation value to be set or changed and press soft key
[NO.SRH].
4 To set a compensation value, enter a value and press soft key [INPUT].
To change the compensation value, enter a value to add to the current
value (a negative value to reduce the current value) and press soft key
[+INPUT]. Or, enter a new value and press soft key [INPUT].
1 Press the
VAR
key to display the offset screen.
2 Use the cursor keys or enter
No.
<(number key)>
INPUT
to display the
offset number to be set.
>H001= 0.000
>H002= 0.000
11.4.1
Setting and Displaying
the Tool Offset Value
Procedure for CRT/MDI
Procedure for DPL/MDI

Leave a Reply

Your email address will not be published. Required fields are marked *