Fanuc Power Mate i-D/H Operator Manual

11. SETTING AND DISPLAYING DATA
B–63174EN/03
OPERATION
534
6 Move the cursor to the compensation number for the target tool (the
cursor can be moved in the same way as for setting tool compensation
values).
7 Press the address key
Y
.
If either
X
key is depressed instead of
Y
key, the X axis relative
coordinate value is input as a tool length compensation value.
8 Press the soft key
[INP.C.]. The Y axis relative coordinate value is
input and displayed as an tool length offset value.
A prefixed position
Reference
tool
The difference is set as a tool
length offset value
INP.C.

Leave a Reply

Your email address will not be published. Required fields are marked *