Fanuc Power Mate i-D/H Operator Manual

11. SETTING AND DISPLAYING DATA
B–63174EN/03
OPERATION
536
4 Move the cursor to the item to be changed by pressing cursor keys
, , , or .
5 Enter a new value and press soft key
[INPUT].
1 Press the
VAR
key to display the settings screen.
> TVON=0
ISO=1
2 Use the cursor keys to move the cursor to the item to be changed.
3 Enter either “0” or “1”, according to the explanation below.
4 Press
INPUT
key. Each parameter is set and displayed.
Setting whether parameter writing is enabled or disabled.
0 : Disabled
1 : Enabled
Setting to perform TV check.
0 : No TV check
1 : Perform TV check
Setting code when data is output through reader puncher interface.
0 : EIA code output
1 : ISO code output
Setting a program input unit, inch or metric system
0 : Metric
1 : Inch
Using channel of reader/puncher interface.
0 : Channel 0
1 : Channel 1
2 : Channel 2
4 : Memory card slot
Setting of whether to perform automatic insertion of the sequence number
or not at program edit in the EDIT mode.
0 : Does not perform automatic sequence number insertion.
1 : Perform automatic sequence number insertion.
Setting of mirror image ON/OFF for each axes.
This setting cannot be made with the DPL/MDI and DPL/MDI operation
package.
0 : Mirror image off
1 : Mirror image on
Procedure for DPL/MDI
Contents of settings
PARAMETER WRITE
(PWE)
TV CHECK (TVON)
PUNCH CODE (ISO)
INPUT UNIT (INCH)
I/O CHANNEL (I/O)
SEQUENCE NO. (SEQ)
MIRROR IMAGE

Leave a Reply

Your email address will not be published. Required fields are marked *