Fanuc Power Mate i-D/H Operator Manual

11. SETTING AND DISPLAYING DATA
B–63174EN/03
OPERATION
538
Various run times, the total number of machined parts, number of parts
required, and number of machined parts can be displayed. This data can
be set by parameters or on this screen (the total number of machined parts
and the time during which the power is on can be set only by parameters).
This screen can also display the clock time.
The time can be set on the screen. When the bit 7 (NCT) of parameter No.
6700 is set 0, the time is not displayed.
Displaying and Setting Run Time, Parts Count and Time
1 Select the MDI mode.
2 Press function key
OFFSET
SETTING
.
3 Press chapter selection soft key
[SETING].
4 Press page key
PAGE
or
PAGE
several times until the following screen
is displayed.
SETTING (TIMER) O0001 N0000
> _ S 0 T0000
MDI **** *** *** 16:05:59
PARTS TOTAL = 14
PARTS REQUIRED = 0
PARTS COUNT = 23
POWER ON = 4H 31M
OPERATING TIME = 0H 0M 0S
CUTTING TIME = 0H 37M 5S
FREE PURPOSE = 0H 0M 0S
CYCLE TIME = 0H 0M 0S
DATE = 1998/07/05
TIME = 11:32:52
[][][][][]OFFSET SETING (OPRT)
5 To set the number of parts required, move the cursor to PARTS
REQUIRED and enter the number of parts to be machined.
6 To set the clock, move the cursor to DATE or TIME, enter a new date
or time, then press soft key [INPUT].
11.4.4
Displaying and Setting
Run Time, Parts Count
and Time
Procedure for CRT/MDI

Leave a Reply

Your email address will not be published. Required fields are marked *