Fanuc Power Mate i-D/H Operator Manual

11. SETTING AND DISPLAYING DATA
B–63174EN/03
OPERATION
540
Negative value cannot be set. Also, the setting of “M” and “S” of run time
is valid from 0 to 59.
Negative value may not be set to the total number of machined parts.
Neither negative value nor the value exceeding the value in the following
table can be set.
Item Maximum value Item Maximum value
Year 2085 Hour 23
Month 12 Minute 59
Day 31 Second 59
Restrictions
Run time and part count
settings
Time settings

Leave a Reply

Your email address will not be published. Required fields are marked *