Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
11. SETTING AND DISPLAYING DATA
OPERATION
543
This subsection uses an example to describe how to display or set
machining menus (pattern menus) created by the machine tool builder.
Refer to the manual issued by the machine tool builder for the actual
pattern menus and pattern data. See II–PROGRAMMING for the pattern
data entry function.
Machining menus cannot be displayed with the DPL/MDI and DPL/MDI
operation package.
Displaying the Pattern Data and the Pattern Menu
1 Press function key
OFFSET
SETTING
.
2 Press the continuous menu key
, then press chapter selection
soft key [MENU].
The following screen (pattern menu screen) is displayed:
1. BOLT HOLE
2. GRID
3. LINE ANGLE
4. TAPPING
5. DRILLING
6. BORING
7. POCKET
8. PECK
9.
10.
MENU : HOLE PATTERN O0000 N00000
> _
MDI **** *** ***
16:05:59
[][][][][]MACRO MENU (OPRT)
3 Enter a pattern number and press soft key [SELECT].
In this example, press
1
, then press [SELECT].
The following screen (bolt hole screen) is displayed:
11.4.6
Displaying Pattern Data
and Pattern Menu
Procedure for CRT/MDI
MENU
Continuous menu key

Leave a Reply

Your email address will not be published. Required fields are marked *