Fanuc Power Mate i-D/H Operator Manual

11. SETTING AND DISPLAYING DATA
B–63174EN/03
OPERATION
546
4 Move the cursor to the desired switch by pressing cursor key or
.
5 Push the cursor move key
or to match the mark to an
arbitrary position and set the desired condition.
6 Press one of the following arrow keys to perform jog feed. Press the
5
key together with an arrow key to perform jog rapid traverse.
31
8
2
4
5 6
9
7
The valid operations on the software operators panel are shown below.
Whether to use the CRT or machine operators panel for each group of
operations can be selected by parameter 7200.
Group1 : Mode selection
Group2 : Selection of jog feed axis, jog rapid traverse
Group3 : Selection of manual pulse generator feed axis, selection of
manual pulse magnification x1, x10, x100
Group4 : Jog feederate, feederate override, rapid traverse override
Group5 : Optional block skip, single block, machine lock, dry run
Group6 : Protect key
Group7 : Feed hold
The groups for which the machine operators panel is selected by
parameter 7200 are not displayed on the software operators panel.
When the CRT indicates other than the software operators panel screen,
position display screen and diagnostic screen, jog feed is not conducted
even if the arrow key is pushed.
The feed axis and direction corresponding to the arrow keys can be set
with parameters (Nos.7210 to 7217).
Eight optionally definable switches are added as an extended function of
the software operators panel. The name of these switches can be set by
parameters (Nos.7220 to 7283) as character strings of max. 8 characters.
For the meanings of these switches, refer to the manual issued by machine
tool builder.
Explanations
Valid operations
Display
Screens on which jog
feed is valid
Jog feed and arrow keys
General purpose
switches

Leave a Reply

Your email address will not be published. Required fields are marked *