Fanuc Power Mate i-D/H Operator Manual

11. SETTING AND DISPLAYING DATA
B–63174EN/03
OPERATION
548
When the CNC and machine are connected, parameters are set to
determine the specifications and functions of the machine in order to fully
utilize the characteristics of the servo motor. The setting of parameters
depends on the machine. Refer to the parameter list prepared by the
machine tool builder.
Normally, the user need not change parameter setting.
Displaying and Setting Parameters
1 Set 1 for PARAMETER WRITE to enable writing. See the
procedure for enabling/disabling parameter writing described below.
2 Press function key
SYSTEM
.
3 Press chapter selection soft key [PARAM] to display the parameter
screen.
PARAMETER (SETTING) O0010 N00002
0000 SEQ INI ISO TVC
0 0 0 0 0 0 0 0
0001
0 0 0 0 0 0 0 0
0002
0 0 0 0 0 0 0 0
0012 MIR
X 0 0 0 0 0 0 0 0
Y 0 0 0 0 0 0 0 0
> _
MDI **** *** *** 16:05:59
[][][][][]PARAM DGNOS PMC SYSTEM (OPRT)
4 Move the cursor to the parameter number to be set or displayed in
either of the following ways:
Enter the parameter number and press soft key [NO.SRH] .
Move the cursor to the parameter number using the page keys,
PAGE
and
PAGE
, and cursor keys, , , , and .
5 To set the parameter, enter a new value with numeric keys in MDI
mode and press soft key
[INPUT]. The parameter is set to the entered
value and the value is displayed.
6 Set 0 for PARAMETER WRITE to disable writing.
11.5.1
Displaying and Setting
Parameters
Procedure for CRT/MDI

Leave a Reply

Your email address will not be published. Required fields are marked *