Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
11. SETTING AND DISPLAYING DATA
OPERATION
551
5 Move the cursor to the number of the parameter to change.
Method 1
Use the cursor keys. The cursor will continue to move while a
cursor key is being pressed.
Method 2
Press the following keys and enter data in the order shown:
No.
<(parameter No.)>
INPUT
6 Press the
INPUT
key. The parameter value is input and displayed.
7 After all parameters have been set and confirmed, return to
8 the settings screen and set PWE to 0.
9 Normally, in order to release the alarm state, press the
CAN
key.
However, in order to release alarm No. 000, the power needs to be
turned off and then on again.
See V–8 for setting parameters with external input/output devices such
as the Handy File.
Some parameters are not effective until the power is turned off and on
again after they are set. Setting such parameters causes alarm 000. In this
case, turn off the power, then turn it on again.
Refer to the FANUC Power Mate i–MODEL D/H Parameter Manual
(B–63180EN) for the parameter list.
Some parameters can be set on the setting screen if the parameter list
indicates “Setting entry is acceptable”. Setting 1 for
PARAMETER
WRITE is not necessary when these parameters are set on the setting
screen.
Explanations
Setting parameters with
external input/output
devices
Parameters that require
turning off the power
Parameter list
Setting data

Leave a Reply

Your email address will not be published. Required fields are marked *