Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
11. SETTING AND DISPLAYING DATA
OPERATION
555
The current mode, automatic operation state, alarm state, and program
editing state are displayed on the next to last line on the CRT screen
allowing the operator to readily understand the operation condition of the
system.
If data setting or the input/output operation is incorrect, the CNC does not
accept the operation and a warning message is displayed on the next to last
line of the CRT screen. This prevents invalid data setting and input/output
errors.
EDIT STOP MTN FIN ALM hh:mm:ss
––EMG––
(7)
(1)
(2) (3) (4)
(5)
(6)
(Display soft keys)
(8) Data is out of range.
(Note) Actually, (8) is displayed in the area starting from (2).
(Note) Actually, 5 is displayed in
the area for (3) and (4).
INPUT
(8)
PATH1
(10)
MDI : Manual data input, MDI operation
AUTO : Automatic operation (AUTO operation)
EDIT : Memory editing
RMT : Automatic operation (DNC operation)
JOG : Jog feed
TJOG : TEACH IN JOG/HANDLE
STEP : Manual incremental feed
ZRN : Manual reference position return
**** : Reset (When the power is turned on or the state in which
program execution has terminated and automatic operation has
terminated.)
STOP : Automatic operation stop (The state in which one block has
been executed and automatic operation is stopped.)
HOLD : Feed hold (The state in which execution of one block has been
interrupted and automatic operation is stopped.)
STRT : Automatic operation start–up (The state in which the system
operates automatically)
MTN : Indicates that the axis is moving.
DWL : Indicates the dwell state.
*** : Indicates a state other than the above.
FIN : Indicates the state in which an auxiliary function is being
executed. (Waiting for the complete signal from the PMC)
*** : Indicates a state other than the above.
––EMG––
: Indicates emergency stop. (Reversed display)
–RESET– : Indicates that the reset signal is being received.
–WAIT– : Waits for MCC to turn on if the servo alarm for MCC
being turned off has been disabled.
11.6.2
Displaying the Status
and Warning for Data
Setting or Input/Output
Operation
Explanations
Description of each
display (CRT/MDI)
(1) Current mode
(2) Automatic operation
status
(3) Axis moving
status/dwell status
(4) State in which an
auxiliary function is
being executed
(5) Emergency stop or
reset status

Leave a Reply

Your email address will not be published. Required fields are marked *