Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
13. HELP FUNCTION
OPERATION
565
5 To return to the OPERATION METHOD menu screen, press the
RETURN MENU key to display “[OPR]” again, and then press the
[OPR] key again.
To directly select another
OPERATION METHOD screen on the screen
shown in Fig.13 (h), enter an item No. from the keyboard and press
the
[SELECT] key.
AUTO
**** *** ***
> 3
Fig.13 (i) How to select another OPERATION METHOD screen
10:00:00
S 0 T0000
[][][][][]SELECT
6 If you are not sure of the No. of a system parameter to be set, or to refer
to a system parameter, press the [PARA] key on the
HELP (INITIAL
MENU) screen. A list of parameter Nos. for each function is displayed.
(See Fig.13 (j).)
It is possible to change the displayed page on the parameter screen.
The current page No. is shown at the upper right corner on the screen.
HELP (PARAMETER TABLE) 01234 N00001
1/4
* SETTEING (No. 0000~)
* READER/PUNCHER INTERFACE (No. 0100~)
* AXIS CONTROL/SETTING UNIT (No. 1000~)
* COORDINATE SYSTEM (No. 1200~)
* STROKE LIMIT (No. 1300~)
* FEED RATE (No. 1400~)
* ACCEL/DECELERATION CTRL (No. 1600~)
* SERVORELATED (No. 1800~)
* DI/DO (No. 3000~)
AUTO
**** *** ***
Fig.13 (j) PARAMETER TABLE screen
10:00:00
S 0 T0000
[][][][][]ALAM OPR PARA (OPRT)
7 To exit from the help screen, press the
HELP
key or another function
key.
RETURN MENU key
PARAMETER TABLE
screen

Leave a Reply

Your email address will not be published. Required fields are marked *