Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
1. DAILY MAINTENANCE
MAINTENANCE
573
(3) Replacing the lithium battery
(a) Prepare a new lithium battery (ordering drawing number:
A02B–0200–K102).
(b) Turn the Power Mate i on for about 30 seconds.
(c) Turn the Power Mate i off.
(d) Remove the old battery from the top of the Power Mate i control
unit.
First unlatch the battery, remove it from the battery holder, and
detach its connector. The battery holder is on top of the face plate
(or the memory connector) on the base printed–circuit board.
Battery latch
Lithium battery
Battery connector
(e) Remove the old battery, insert a new one into the battery holder,
and attach the connector. Confirm that the battery is latched
firmly.
WARNING
Using other than the recommended battery may result in the
battery exploding.
Replace the battery only with the specified battery
(A02B–0200–K102).
CAUTION
Complete the steps (c) to (e) within 30 minutes.
If the battery is left disconnected for a long time, the
contents of memory will be lost.
If there is a possibility that the replacement is not completed
within 30 minutes, save the whole contents of the CMOS
memory to a memory card in advance. The data can be
easily restored in case the memory contents are lost.
For the operating procedure, refer to the maintenance
manual (B–63175EN).

Leave a Reply

Your email address will not be published. Required fields are marked *