Fanuc Power Mate i-D/H Operator Manual

G. ALARM LIST
B–63174EN/03
APPENDIX
616
No. RemedyDescriptionMeaning
Alarm
No.
Message
7n58 SPN_n_ : OVERLOAD IN
PSM
AL–58 Overload on
the PSM main
circuit
The temperature of the radia-
tor of the main circuit has in-
creased abnormally. (Cooling
fan failure, dirt in the cooling
fan, overload operation, etc.)
Eliminate the cause, then
reset the alarm.
7n59 SPN_n_ : COOLING FAN
STOP IN PSM
AL–59 The PSM cool-
ing fan
stopped.
The cooling fan of the control
circuit section stopped.
Check the turning state of
the cooling fan. Replace
the cooling fan.
17) Error codes at high–speed response function compile time
Number Contents
0003 Data exceeding the maximum allowable number of digits was input.
0004 A number or the sign ”–” was input without an address at the beginning of a block.
0005 The address was not followed by the appropriate data but was followed by another address or EOB code.
Or, this error occurs when one of the following commands is specified.
A number is not specified after ’#’.
Example) #A
An address is specified after ’=’. A number or ’#’ must be specified after ’=’.
Example) =A
0006 Sign ”–” input error(Sign ”–” was input after an address with which it cannot be used. Or two or more ”–” signs
were input.)
The sign ” – ” is specified for the variable number
Example) #–1000000
0007 Decimal point ”.” input error (A decimal point was input after an address with which it can not be used.)
0009 Unusable character was input in significant area.
0010 An unusable G code is specified.
0011 The feedrate was inadequate.
(1) Feedrate was not commanded to a cutting feed.
(2) Feedrate is 0.
0015 The number of the commanded axes exceeded that of simultaneously controlled axes.
0053 Camma ”,” was input. ( Camma ”,” can not be input.)
0070 The memory area is insufficient.
0113 Sharp ”#” was input. (Sharp ”#” can not be input.)
This error occurs when one of the following commands is specified.
The macro variable ’#’ is specified for G code.
Example) G#1000000
The macro variable ’#’ is specified for M code.
Example) M#1000000
The macro variable ’#’ is specified for the optional block skip number.
Example) /#1
The macro variable ’#’ is specified for the parameter of the M code output function.
Example) M____ P____ Q#____

Leave a Reply

Your email address will not be published. Required fields are marked *