Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
G. ALARM LIST
APPENDIX
619
Number Contents
1094 The G code belonging to the G code group 01 is specified in the block including the optional block skip.
1096 The G code belonging to the G code group 03 is specified in the block including the optional block skip.
1100 No axis was specified in this program.
1101 No program (O8000 to O8031) to compile is found.
1102 An unusable program number for the motion program is specified at the function to compile the program by
the signal.
1800 One or more motion program are executing.
1821 Compiling operation is done during reset state.
1822 Compiling operation is done during alarm state.
1823 Compiling operation is done during the automatic operation.
1824 The editing of a main program and a sub–program is forbidden according to the following parameters.
Parameter No.3202#0(NE8),#4(NE9)
Parameter No.3204#3(P8E),#4(P9E)
Ex.) In case only main programs exist
If NE8=1, an error occurs at compiling.
Ex.) In case a sub–programs also exists
In case sub–program numbers are within 8032 to 8999.
(The area of sub–program number is specified by the parameter No.8691 and No.8692)
If NE8=1, an error occurs at compiling.
In case sub–program numbers are within 8032 to 9999.
If NE8=1 and NE9=1, an error occurs at compiling.
In case sub–program numbers are within 80000000 to 89999999
If NE8=1 and P8E=1, an error occurs at compiling.
In case sub–program numbers are within 90000000 to 99999999.
If NE8=1 and P9E=1, an error occurs at compiling.
1825 Program is protected because the memory protect is enabled.
1826 Background editing is executing.

Leave a Reply

Your email address will not be published. Required fields are marked *