Fanuc Power Mate i-D/H Operator Manual

H. LIST OF OPERATION
B–63174EN/03
APPENDIX
620
H
LIST OF OPERATION
Reset
Function
KEY
SW
SETTING
PWE=1
Mode
Function
key
Operation
Resetting the operating time _ _ [(OPRT)] [TIME: 0] [EXEC]
Resetting the number of
machined parts
_ _ [(OPRT)] [TIME: 0] [EXEC]
Resetting the OT alarm When the
power is on
_
P CAN
CRT/MDI
and
Touch panel manufactured by FANUC
Turn on the power while holding down
the top–right corner of the screen.
Display the IPL screen, then
P [SELECT] [YES]
CAN [SELECT] [YES] [YES]
Resetting alarm 100 _ _
RESET
CAN
CRT/MDI
and
Touch panel manufactured by FANUC
SPCL CAN RESET
ENTER
Data input from the MDI
Function
KEY
SW
SETTING
PWE=1
Mode
Function
key
Operation
Inputting parameters _ SYSTEM
(PARAM)
Parameter No. [NO.SRH] Data
INPUT PWE = 0
INPUT
RESET
Inputting offset data OFF _ OFFSET Offset No. [NO.SRH] Offset
value INPUT
Inputting setting data OFF _ SETTING
Setting No. [NO.SRH] Data INPUT
Inputting PMC parameters
(for the counter and data table)
OFF MDI or
emergency
stop
SYSTEM
(PMC)
[PMCPRM] [COUNTR] Data
[DATA]
INPUT
Inputting PMC parameters
(for the timer and keep relay)
[PMCPRM] [TIMER] Data
[KEEPRL]
INPUT
Tool length compensation JOG POS
OFFSET
POS (Display of relative coordinate system)
AXIS [ORIGN] OFFSET
More the tool measuvment position
Offset No. [NO.SRH] AXIS [C INPUT]

Leave a Reply

Your email address will not be published. Required fields are marked *