Fanuc Power Mate i-D/H Operator Manual

H. LIST OF OPERATION
B–63174EN/03
APPENDIX
628
Function Operation
Function
key
Mode
SETTING
PWE=1
KEY
SW
Program collation EDIT PARAM
N File number
READ READ
PMC parameter Ladder program
input
Only when
PMC
Emergency
stop
DGNOS/
PARAM
DGNOS screen No.
File number READ
Data type is automatically
identified.
PMC parameter output EDIT DGNOS/
PARAM
PMC parameter display
No. File number WRITE
Ladder program output DGNOS/
PARAM
DGNOS screen No.
File number WRITE
WARNING
1 After completion of ladder program input, the power must be turned on again because the
ladder program is in halt state.
2* The ladder program in FROM is not cleared.
Switching of 1–path mode (Power Mate i–D) and 2–path mode (Power Mate i–D2)
Function
KEY
SW
SETTING
PWE=1
Mode
Function
key
Operation
From 1–path mode to 2–path
mode
When the
power is on
_
CRT/MDI, DPL/MDI
Turn on the power while holding down S and
2
Touch panel manufactured by FANUC
Turn on the power while holding down
Turn on the power while holding down
the top–right corner of the screen.
Display the IPL screen, then
S [SELECT] [YES]
1 [SELECT] [YES] [YES]
From 2–path mode to 1–path
mode
When the
power is on
_
CRT/MDI, DPL/MDI
Turn on the power while holding down S and
1
Touch panel manufactured by FANUC
Turn on the power while holding down
Turn on the power while holding down
the top–right corner of the screen.
Display the IPL screen, then
S [SELECT] [YES]
2 [SELECT] [YES] [YES]

Leave a Reply

Your email address will not be published. Required fields are marked *