Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
H. LIST OF OPERATION
APPENDIX
629
NOTE
When this operation is performed, all CNC data including offset values and macro variables
stored in the battery–powered memory (SRAM) is cleared. The parameters are reset to the
factory–set values. So, the CNC data such as the parameters, offset values, and macro
variables needs to be set again.
Optional parameters can not be cleared by this operation.
Path selection operation needs to be performed only once at the time of switching to path
control. Path selection operation need not be performed each time the power is turned on.
Even if the power is turned on again while the 1 and S keys are held down in the 1–path
mode, or the power is turned on again while the 2 and S keys are held down in the 2–path
mode, all SRAM data is cleared.
If a memory all–clear operation is performed, the path selection data returns to the 1–path mode
selection state.
Switching between the 1–path mode and 2–path mode (Power Mate i–D2)
Function
KEY
SW
SETTING
PWE=1
Mode
Function
key
Operation
From 1–path mode to 2–path
mode
_
CRT/MDI, DPL/MDI
Press H and 2 simultaneously.
Touch panel manufactured by FANUC
SPCL H 2 ENTER
From 2–path mode to 1–path
mode
_
CRT/MDI, DPL/MDI
Press H and 1 simultaneously.
Touch panel manufactured by FANUC
SPCL H 1 ENTER

Leave a Reply

Your email address will not be published. Required fields are marked *