Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Common to Power Mate i–D and –H)
B–63174EN/03
10. AUXILIARY FUNCTION
77
10
AUXILIARY FUNCTION
There are two types of auxiliary functions ; auxiliary function (M code)
for specifying program end.
When a move command and auxiliary function are specified in the same
block, the commands are executed in one of the following two ways:
(i) Simultaneous execution of the move command and auxiliary
function commands.
(ii) Executing auxiliary function commands upon completion of move
command execution.
The selection of either sequence depends on the machine tool builders
specification. Refer to the manual issued by the machine tool builder for
details.
General

Leave a Reply

Your email address will not be published. Required fields are marked *