Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Common to Power Mate i–D and –H)
B–63174EN/03
11. PROGRAM CONFIGURATION
81
A program consists of the following components:
Table 11 Program components
Components Descriptions
Tape start Symbol indicating the start of a program file
Leader section Used for the title of a program file, etc.
Program start Symbol indicating the start of a program
Program section Commands for machining
Comment section Comments or directions for the operator
Tape end Symbol indicating the end of a program file
Tape start
% TITLE ;
O0001 ;
M30 ;
%
(COMMENT)
Program section
Leader section
Program start
Comment section
Tape end
Fig.11 (b) Program configuration
A program section consists of several blocks. A program section starts
with a program number and ends with a program end code.
Program section
Program section
configuration
Program number O0001 ;
Block 1 N1 G91 G00 X120.0 ;
Block 2 N2 G43 Z–32.0 H01 ;
: :
Block n Nn M2 ;
Program end M30 ;
A block contains information necessary for machine operation, such as
a move command or on/off command of peripheral device. Specifying
a value following a slash (/) at the start of a block disables the execution
of some blocks (see “optional block skip” in Section II–11.2).
Program components
Program section
configuration

Leave a Reply

Your email address will not be published. Required fields are marked *