FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
B63173EN/03
102
CM52(33), CMB3(33), CMB4(07)
Power Mate
Example of
connection
0V
CMB3(12)
CMB3(29)
CMB3(45)
CMB3(30)
CMB3(14)
CMB3(31)
CMB3(13)
CMB3(46)
Yn+4. 0
Bit number
Address number
Pin number
Regulated
power supply
+24V 0V
DOC
CMB3(17, 50)
CMB4(20)
Sourcetype
driver
Yn+4. 1
Yn+4. 2
Yn+4. 3
Yn+4. 4
Yn+4. 5
Yn+4. 6
Yn+4. 7
DO40
DO41
DO42
DO43
DO44
DO45
DO46
DO47
Fig. 6.6.4 (e) I/O card machine interface (17)
Yn+4.0 to Yn+4.7 correspond to one driver device.
If an error occurs in the device, the DAL5 LED on the PC board lights.
NOTE
This connection cannot be used for I/O card D
(A16B22020733).

Leave a Reply

Your email address will not be published. Required fields are marked *