FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
B63173EN/03
106
Approx.100mm
The following LEDs, fuses, variable resistors, and setting pins are
mounted on the PCB:
[LEDs]
DB2 (green, pilot) : Lights while the power to the PCB is on.
DB1 (red, alarm) : Lights if an error occurs in the PCB or Power Mate.
DAL1 to DAL8 : Do driver at overheat
[Fuses]
FU1 (3.2 A) : Used for external 24V input.
(Order number : A02B0200K103)
FU2 (5.0 A) : Used for +5 V on the PCB.
(Order number : A02B0200K103)
[Variable resistors]
VR1 and VR2 : Factoryset by FANUC. The machine tool builder
need not adjust these resistors.
[Setting pin]
CP1 : Used to specify whether the Power Mate will be
notified of a DO signal error as a system alarm.
Open : Notify
Short : Not notify
6.6.5
Dimensions of I/O Card
D, E

Leave a Reply

Your email address will not be published. Required fields are marked *