FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
123
When connecting a connector panel printed circuit board directly
(external module view and mounting diagram)
Dimensions of connector panel
printed circuit board
Board thickness 1.6 mm
Square hole
I/O interface
Square
hole
I/O Link
interface
MPG interface
(for extension A)
No. 1 pin
Note)
Connector panel printed circuit board connector specification:
HONDA MRH50FD
(50pin female straight connector without fitting)
NOTE
1 A connector with a fitting (HONDA MRH50RMA) is used for
the moduleside I/O interface. Always use a connector
having no fitting for the connector panel printed circuit
board.
2 Area where pattern printing is prohibited
Prohibited area on soldered side
Prohibited area on component side
6.7.9
Module Installation

Leave a Reply

Your email address will not be published. Required fields are marked *