FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

1. PREFACE
B63173EN/03
2
This manual consists of Chapters 1 to 11 and Appendixes.
Chapter title Description
Chapter 2
CONFIGURATION
Outlines connections for the Power Matei and guides the reader concerning
additional details.
Chapter 3
INSTALLATION
This chapter describes the installation conditions for the Power Matei
1) Environmental requirements
2) Required power supply
3) Heat generated
4) Noise prevention
5) Connector arrangement on the control unit
Chapter 4
TOTAL CONNECTION DIAGRAM
This chapter shows the total connection diagram.
Chapter 5
CONNECTING THE POWER SUPPLY
This chapter describes how to connect the power supply.
Chapter 6
CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
This chapter describes how to connect the machine operators panel and power
magnetics.
Chapter 7
CONNECTION TO FA NETWORKS
This chapter introduces FA networks such as Ethernet and DeviceNet and
lists reference manuals.
Chapter 8
CONNECTION TO SETTING AND
DISPLAY UNIT
This chapter describes how to connect the following setup/display devices to
the Power Mate i:
1) CRT/MDI unit interface
2) Interface between standalone type CRT, standalone type MDI, and
Power Mate
3) Interface between standalone type PDP, standalone type MDI, and
Power Mate
4) LCD/MDI, standalone type LCD, and standalone type MDI interface
5) Connection to a detachable LCD/MDI unit
6) Detachable LCD/MDI type B
7) Connection to the handy operators panel
8) Connection to the handy operators panel type B
9) Connection to an LCD with a touch panel
Chapter 9
CONNECTION TO SERVO OR SPINDLE
This chapter describes how to connect servoamplifier and spindleamplifi-
errelated devices to the Power Mate i.
1) Servo interface (FSSB)
2) Separate detector interface unit
3) Connecting the FANUC servo unit b series with I/O link
4) Spindle interface
5) Analog servo interface unit
6) Connecting servo check boards
Chapter 10
CONNECTION TO PERIPHERALS
This chapter describes how to connect peripheral devices to the Power Mate
i.
1) I/O device interface
2) External pulse input interface
3) Manual pulse generator interface
4) Analog input function
5) Connection to a commercially available touch panel
6) Connection by multiaxis synchronization function (Power Mate iH only)
7) Handy machine operators panel
Configuration of the
manual

Leave a Reply

Your email address will not be published. Required fields are marked *