FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
B63173EN/03
142
d A maximum of 56 points are provided.
Xn+10.0 Xn+10.1 Xn+10.2 Xn+10.3 Xn+10.4 Xn+10.5 Xn+10.6 Xn+10.7
Xn+9.0 Xn+9.1 Xn+9.2 Xn+9.3 Xn+9.4 Xn+9.5 Xn+9.6 Xn+9.7
Xn+8.0 Xn+8.1 Xn+8.2 Xn+8.3 Xn+8.4 Xn+8.5 Xn+8.6 Xn+8.7
Xn+7.0 Xn+7.1 Xn+7.2 Xn+7.3 Xn+7.4 Xn+7.5 Xn+7.6 Xn+7.7
Xn+6.0 Xn+6.1 Xn+6.2 Xn+6.3 Xn+6.4 Xn+6.5 Xn+6.6 Xn+6.7
Xn+5.0 Xn+5.1 Xn+5.2 Xn+5.3 Xn+5.4 Xn+5.5 Xn+5.6 Xn+5.7
Xn+4.0 Xn+4.1 Xn+4.2 Xn+4.3 Xn+4.4 Xn+4.5 Xn+4.6 Xn+4.7CE53(A23)
*KCM1
CE53(B23)
*KCM2
CE53(A24)
*KCM3
CE53(B24)
*KCM4
CE54(A23)
*KCM5
CE54(B23)
*KCM6
CE54(A24)
*KCM7
CE53(A19)
*KYD0
CE53(B19)
*KYD1
CE53(A20)
*KYD2
CE53(B20)
*KYD3
CE53(A21)
*KYD4
CE53(B21)
*KYD5
CE53(A22)
*KYD6
CE53(B22)
*KYD7
NOTE
Detour prevention diodes must be incorporated for matrix
signal input, as shown in the following figure. Otherwise,
only two signals can be input at the same time. Inputting
three or more signals simultaneously without using detour
prevention diodes may result in data input errors.
6.8.5
DI (Matrix Input Signal)
Connection

Leave a Reply

Your email address will not be published. Required fields are marked *