FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

2. CONFIGURATION
B63173EN/03
4
2
CONFIGURATION
The following figure shows the configuration of the electrical system of
the machine tool and industrial machine with which this control is used.
This manual describes how to connect the units illustrated in Fig. 2. The
machine body, machine operators panel, power magnetic circuit, and
sensor/actuator are specific to the machine and are the builders
responsibility. This manual does not cover the internal connection of
these units to the machine tool. The numbers in parentheses shown in the
diagram are section references for this manual.

Leave a Reply

Your email address will not be published. Required fields are marked *