FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
173
Connect the following stabilizedpower source to the connector CP32 of
the interface module (AIF01A or AIF01B).
D Voltage : 24VDC"10% (including an instantaneous value and ripple)
D Current : Determine from Table 6.10.6.
+24V
2
1
GND
3
CP32
AIF01A/AIF01B
FCI JAPAN, LTD. tripolar connector (Brown)
Housing : SMS3PNS5
Contact : RC16MSCT3
24VDC
J24
FANUC specification:
A02B0072K893
NOTE
Turn ON the power for the I/O UnitA just before or when the
power for the Power Mate is turned ON. When the Power
Mate power is turned OFF, make sure to turn the power to
the I/O UnitA OFF as well.
t
ON
OFF
ON
OFF
Power for the
I/O Link master
Power for the
I/O UnitA
t : more than 500ms
(Turn ON of the power for I/O UnitA can be late 500ms or less.)
6.10.5
Connecting Input
Power Source

Leave a Reply

Your email address will not be published. Required fields are marked *