FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
181
0 A7A6A5A4A3A2A1A0
#7 #6 #5 #4 #3 #2 #1 #0
1 B7B6B5B4B3B2B1B0
2 C7C6C5C4C3C2C1C0
3 D7D6D5D4D3D2D1D0
Address in the
module
Module of 8
points
Module of 16
points
Module of
32 points
Bit
Addresses in a module are defined relatively, with the beginning address
as 0. Real addresses viewed by the sequence program of the PMC are set
by the programmer.
For input modules, an input signal becomes 1 when the contact point
connected with the input is turned ON. For output modules, an output
contact point (or transistor) is turned ON when the output signal is 1.
6.10.10
Correspondence
between I/O Signals
and Addresses in a
Module

Leave a Reply

Your email address will not be published. Required fields are marked *