FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
185
LED5
(GREEN)
LED3
(RED)
LED4
(GREEN)
LED2
(RED)
LED1 (RED)
+5V
0V
DCDC
CONVERTER
: Check pin
Channel 2 Channel 1
Power supply
connector
CP2
Power supply
connector
CP1
I/O Link connector
to the next stage
JD1A2
(COPA2)
I/O Link connector
from preceding
stage
JD1B2
(COPB2)
I/O Link connector
to the next stage
JD1A1
(COPA1)
I/O Link connector
from preceding
stage
JD1B1
(COPB1)
Fig. 6.11.2 (a) LED locations
LED status Description
LED1 j Normal
1
LED1 J
A RAM parity error occurred because of a
hardware failure.
LED4 LED2
J j
CP1 is supplied with the specified voltage.
(Pilot lamp)
2
LED4 LED2
j J
CP1 is supplied with a voltage that is lower than
specified or zero.
LED4 LED2
J J
A communication error occurred in a channel of
CP1.
LED5 LED3
J j
CP2 is supplied with the specified voltage.
(Pilot lamp)
3
LED5 LED3
j J
CP2 is supplied with a voltage that is lower than
specified or zero.
LED5 LED3
J J
A communication error occurred in a channel of
CP2.
J: ON j: OFF
LED indications

Leave a Reply

Your email address will not be published. Required fields are marked *