FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
B63173EN/03
188
(2)Signal cable (electrical)
JD1A1/JD1A2 JD1B1/JD1B2
11 0V 1 RXB
12 0V 2 *RXB
13 0V 3 TXB
14 0V 4 *TXB
15 0V 5
16 0V 6
17 7
18 8
19 9
20 10
11 0V 1 RXA
12 0V 2 *RXA
13 0V 3 TXA
14 0V 4 *TXA
15 0V 5
16 0V 6
17 7
18 8
19 9
20 10
This unit (JD1A1/JD1A2) Another device (JD1B)
or
Another device (JD1A) This unit (JD1B1/JD1B2)
RXB (01)
*RXB (02)
TXB (03)
*TXB (04)
(09)
(18)
(20)
0V (11)
0V (12)
0V (13)
0V (14)
0V (15)
0V (16)
(03) TXA
(04) *TXA
(01) RXA
(02) *RXA
(09)
(18)
(20)
(11) 0V
(12) 0V
(13) 0V
(14) 0V
(15) 0V
(16) 0V
Indicates a twisted pair.
Note
Note) An optical I/O Link adapter
cannot be connected to this
unit, because the electrical
interface for this unit cannot
supply +5 V. To use an opti-
cal interface, prepare an ap-
propriate unit.
These wires can, therefore,
be omitted.
Shield
Frame ground (the shield must be grounded at either end of the cable)
S Cableside connector specification: PCRE20FA (manufactured by Honda Tsushin)
S Recommended cable material specification: A66L00010284#10P
S Cable length: 10 m (maximum)

Leave a Reply

Your email address will not be published. Required fields are marked *