FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
191
4) The FSSB cable (optical fiber cable) used should be selected from the
ordering list.
5) The signals directly seen by the CNC, such as emergency stop and skip
signals, must be input from the builtin I/O unit or from the I/O unit
for FANUC I/O Link.
6) When it is ON, the FSSB I/O module cannot be removed from the
FSSB line.
7) To determine when extended units will be ready for shipment, contact
FANUC.
1) Installation requirements
Ambient temperature Operating 0°C to 55°C
Storage and transit 20°C to 60°C
Humidity Same as that for the Power Mate i. (See Section 3.1.)
Vibration Same as above
Contamination Same as above
Ionic (nonionic) radiation Same as above
Height above sea level Same as above
2) Ordering specifications
Name Specification Remarks
FSSB I/O module, basic unit A02B0236C211 DI/DO : 32/24 (points)
FSSB I/O module, extended unit A02B0236C212 DI/DO : 32/24 (points)
Flat cable for the FSSB I/O
module
A02B0236K831
Spare fuse A03B0815K001 Fuse for 24 VDC (1.0A)
6.12.2
Specifications

Leave a Reply

Your email address will not be published. Required fields are marked *