FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
3. INSTALLATION
9
The following unit requires a power supply of 24 VDC "10% (including
instantaneous change and ripple).
NOTE
1 The Power Matei requires an additional 24V power
supply for DOs.
2 Use memory cards that consume no more than 2 W.
Table 3.2 (a) Power supply capacity for control unit
Unit
Power supply capacity
Control unit
(Option board is not included)
1.8 A (Another 1A required for the FANUC
RS232C device is used)
Option board
HSSB board 0.2A
I/O LinkII slave board 0.3A
I/O LinkII slave board B 0.3A
ProfibusDP master board 0.3A
ProfibusDP slave board 0.3A
DeviceNet master board
DeviceNet master board B
DeviceNet slave board
DeviceNet slave board B
DeviceNet slave board C
0.2A
Ethernet board 0.3A
FLnet board 0.3A
3.2
POWER SUPPLY FOR
CNC CONTROL
UNITS

Leave a Reply

Your email address will not be published. Required fields are marked *