FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
199
(1)DI Signals
#7 #6 #5 #4 #3 #2 #1 #0
155AB05155AA06155AB04155AA04155AB03155AA03155AB02155AA02
PMC
ADDRESS
#7 #6 #5 #4 #3 #2 #1 #0
155AB10155AA10155AB09155AA09155AB08155AA08155AB07155AA07
#7 #6 #5 #4 #3 #2 #1 #0
156AB05156AA05156AB04156AA04156AB03156AA03156AB02156AA02
#7 #6 #5 #4 #3 #2 #1 #0
156AB10156AA10156AB09156AA09156AB08156AA08156AB07156AA07
DC input signal B
(2) DO Signals
#7 #6 #5 #4 #3 #2 #1 #0
155AB14155AA14155AB13155AA13155AB12155AA12155AB11155AA11
#7 #6 #5 #4 #3 #2 #1 #0
156AB16156AA16156AB15156AA15155AB16155AA16155AB15155AA15
#7 #6 #5 #4 #3 #2 #1 #0
156AB14156AA14156AB13156AA13156AB12156AA12156AB11156AA11
NOTE
1 For PMC addresses, the R area of the PMC is used. The
DIs and DOs of the FSSB I/O module, the start address of
the R area, and its size are specified with parameters.
2 The above figures show the signals of the basic unit. For the
extended unit, 155A is replaced by 155B, and 156A by
156B.
6.12.7
Signals

Leave a Reply

Your email address will not be published. Required fields are marked *