FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

7. CONNECTION TO FA NETWORKS
B63173EN/03
206
The Power Mate i has two FA network expansion slots for connection to
an upper controller/personal computer and to a lower I/O device.
Up to two of the following boards can be selected. The two must be
different boards.
Table 7.1
Board name Board specification
Relevant
section
Highspeed serial bus (HSSB) board A20B0259J200 Section 7.2
FANUC I/O LinkII slave board A20B0259J210
Section 7.3
FANUC I/O LinkII slave board B A20B0259J282
Ethernet board A20B0259J230 Section 7.4
FANUC FLnet board A20B0259J272 Section 7.5
PROFIBUSDP slave board A20B0259J220
Section 7.6
PROFIBUSDP master board A20B0259J221
DeviceNet slave board A20B0259J240
Section 7.7
DeviceNet slave board B A20B0259J242
DeviceNet master board A20B0259J241
DeviceNet master board B A20B0259J243
NOTE
1 The PROFIBUSDP board cannot be used together with
the DeviceNet board at the same time.
2 The DeviceNet slave board and DeviceNet master board
must be inserted and removed by following special
procedures. There is no special procedure for inserting and
removing the DeviceNet slave board B/C and DeviceNet
master board B.
3 When the PROFIBUSDP slave board and PROFIBUSDP
master board are used at the same time, some restrictions
may be imposed on the cableside connector depending on
the axis control card specified.
CAUTION
This chapter extracts a brief description of each FA network
and an explanation of how to connect each FA network from
related manuals. In actual connection, follow the
instructions described in the relevant manual. If there is a
discrepancy in description between this connection manual
and the relevant manual, the description in the relevant
manual takes priority.
7.1
OVERVIEW

Leave a Reply

Your email address will not be published. Required fields are marked *