FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
7. CONNECTION TO FA NETWORKS
209
The FANUC I/O LinkII board provides an I/O network conforming to
OPCN1, as laid down by the Japan Electric Manufacturers Association
(JEMA). In the Power Mate i, the FANUC I/O LinkII board can be
selected as an FA network option board.
The I/O LinkII function has the features listed below.
(1)A connection can be made with devices (including devices produced
by other manufacturers) that conform to OPCN1.
(2)The power to a slave station on the network can be turned on and off
at any time without affecting communications performed by other
devices.
(3)Up to thirtyone slave stations can be connected to one master station.
(4)The slave function includes a global I/O transfer function (allowing a
slave station to receive DO data from other slave stations).
NOTE
For the I/O LinkII, refer to the FANUC I/O LinkII
Connection Manual (B62714EN).
With the Power Mate i, the I/O LinkII slave board and I/O LinkII slave
board B are used. These two types of slave boards differ in the interface
connector.
The specifications of the I/O LinkII slave board are as follows:
Name I/O LinkII slave board
Ordering code A02B0259J210
Board drawing number A20B81000310
Interface connector Connector manufactured by Phoenix Contact
Power supply capacity 24 VDC "10%, 0.3 A (to be supplied from the
main unit)
Heat dissipation 6 (W)
The specifications of I/O LinkII slave board B are as follows:
Name I/O LinkII slave board B
Ordering code A02B0259J282
Board drawing number A20B81000381
Interface connector Connector manufactured by Hirose Electric
Power supply capacity 24 VDC "10%, 0.3 A (to be supplied from the
main unit)
Heat dissipation 7 (W)
7.3
FANUC I/O LinkII
BOARD
7.3.1
Overview

Leave a Reply

Your email address will not be published. Required fields are marked *