FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
7. CONNECTION TO FA NETWORKS
213
NOTE
A crimp terminal can also be used.
Twist the wires from which the cover is peel off, then install
a crimp terminal.
The following crimp terminal is recommended:
AI series manufactured by Phoenix Contact (Special tool
ZA3)
Connector pin assignment
1 2 3 4 5TBA
Mounting screw
Terminal No. Signal name Signal type
1 T1
A terminating resistor is connected.
(T1/T2 connected)
2 T2
No terminating resistor is connected.
(T1/T2 open)
3 A Data signal A
4 B Data signal B
5 SG Signal ground
Cable connector:
Manufactured by Hirose Electric
HR315.08P5SC (plug)
HR31SC121 x 5 (crimp terminal)
Applicable wire material 0.25 to 1.65 mm
2
The plug is delivered with the board.
Place an order on the crimp terminal (A02B0259K211) separately.
NOTE
The crimp terminal is not delivered with the board.
7.3.5
Connection to
Connector (Slave
Board B)
Connector

Leave a Reply

Your email address will not be published. Required fields are marked *