FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

7. CONNECTION TO FA NETWORKS
B63173EN/03
230
2) Removing the base PCB
Remove the base PCB before you remove the DeviceNet board. For
details on how to remove the base PCB, refer to the respective
Maintenance Manual.
NOTICE
The DeviceNet board cannot be removed unless the base
PCB has been removed first. If the DeviceNet board is
removed without removing the base PCB, the DeviceNet
board may interfere and break the base PCB.
3) Removing the DeviceNet board
Remove the DeviceNet board without the base PCB attached.
For details on how to remove the DeviceNet board, refer to How to
Remove and Attach Optional Boards in the respective Maintenance
Manual.
1) Removing the base PCB
Remove the base PCB before you remove the DeviceNet board. For
details on how to remove the base PCB, refer to the respective
Maintenance Manual.
CAUTION
The DeviceNet board cannot be attached unless the base
PCB has been removed first. If you attempt to attach the
DeviceNet board without removing the base PCB, the
DeviceNet board may interfere and break the base PCB.
2) Removing the DeviceNet connector terminal plate
Remove the interface connector terminal plate from the DeviceNet
board. Loosen the two screws shown in the figure below to remove.
Screws
3) Attaching the DeviceNet board
Attach the DeviceNet board without the base PCB attached.
For details on how to attach the DeviceNet board, refer to How to
Remove and Attach Optional Boards in the respective Maintenance
Manual.
4) Attaching the base PCB
After you have attached the DeviceNet board, attach the base PCB. For
details on how to attach the base PCB, refer to the respective
Maintenance Manual.
Attaching the DeviceNet
board

Leave a Reply

Your email address will not be published. Required fields are marked *