FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

8. CONNECTION TO SETTING AND DISPLAY UNIT
B63173EN/03
246
The Power Mate can be used in conjunction with a standalone type CRT
and a standalone type MDI and a picuture display standalone type MDI.
CN2 (CRT power
supply)
J56
Standalone type
CRT
FG
Power supply of
24VDC 1.0A
J142
Power Mate
JD41
CN1 (video input)
Soft key
cable
JA1
Standalone type
MDI
JD13
JN1
CK2
CPD2
CPD1
J30
Video cable
J53
Mode selection switch
J47
1 Up to 16 Power Mates can be connected to one standalone type CRT
and one standalone type MDI.
Connection is the same as for the CRT/MDI.
2 Terminating method is the same as for the CRT/MDI.
3 The standalone type CRT is supplied with a soft key cable. Connect
this cable to the standalone type MDI. Keep in mind that the length
of this cable is 500 mm when positioning these units. See Appendix
A for the connector position of the soft key cable in standalone type
CRT.
4 The screen can be shared in the same way as for the CRT/MDI.
5 For details concerning cable J142 used to connect a Power Mate and
the standalone type MDI, see Subsection 8.1.2. See Section 8.1.3 for
how to attach the J45 cable for connection with multiple Power Mate
units.
6 For details concerning cable J30 used to connect the power supply to
the standalone type MDI, see Subsection 8.1.5.
8.2
INTERFACE
BETWEEN STAND
ALONE TYPE CRT,
STANDALONE TYPE
MDI, AND Power Mate
8.2.1
Outline

Leave a Reply

Your email address will not be published. Required fields are marked *