FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
8. CONNECTION TO SETTING AND DISPLAY UNIT
247
7 For details concerning cable J47 used to connect the standalone type
MDI to the mode selection switch, see Subsection 8.1.4.
8 Video cable J53 and standalone type CRT power cable J56 are not
supplied with the unit.
9 Always connect the protective ground plates of the standalone type
CRT and standalone type MDI to ground, see Section 5.8
10 All interfaces not described here are the same as those of the
CRT/MDI.
WARNING
To have the standalone type CRT approved for the CE
marking, it is necessary to provide a shock hazard
prevention cover (A02B0200K820). Attaching the cover
to the CRT is the machine tool builders responsibility.

Leave a Reply

Your email address will not be published. Required fields are marked *