FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

3. INSTALLATION
B63173EN/03
14
FSSB I/O module basic unit 7.5 + 0.175 x n (W) where n is the
FSSB I/O module basic unit +
expansion unit
number of input points that are turned
on simultaneously
Analog servo interface unit, basic unit 10W (type F)
17W (type M)
Analog servo interface unit, basic unit
+ expansion unit
14W (type F)
28W (type M)
Unit Heat loss
CRT/MDI
Picture display CRT/MDI
18W
LCD/MDI 14W
Stand alone type CRT 14W
Stand alone type MDI
Picture display stand alone type MDI
4W
Stand alone type PDP 20W
Stand alone type LCD 10W
NOTE
1 For other peripheral devices (I/O, etc.), see the heat
dissipation data for each device and add the value to the
above.
2 Not including the heat dissipation of the separate detector
itself.
3 See FANUC SERVO AMPLIFIER a series DESCRIPTIONS
(B65162E) or FANUC SERVO MOTOR b series
DESCRIPTIONS (B65232EN) for heat loss of servo
amplifier.

Leave a Reply

Your email address will not be published. Required fields are marked *