FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

8. CONNECTION TO SETTING AND DISPLAY UNIT
B63173EN/03
252
The Power Mate can be used in combination with the LCD/MDI,
standalone type LCD, standalone type MDI, or picture display
standalone type MDI.
CP5 (LCD power
supply)
J137
Standalone type
LCD
FG
Power supply of
24VDC" 1.0A
J142
Power Mate
JD41
JA1 (video input)
Soft key
cable
JA1
Standalone type
MDI
JD13
JN1
CK2
CPD2
CPD1
J30
Video cable
J136
Device number selec-
tion switch
J138
1 Up to 16 Power Mates can be connected to LCD/MDI or one
standalone type LCD and one standalone type MDI. Connection is
the same as for the CRT/MDI.
2 Terminating method is the same as for the CRT/MDI.
3 The standalone type LCD is supplied with a soft key cable. Connect
this cable to the standalone type MDI. Keep in mind that the length
of this cable is 500 mm when positioning these units. See Appendix
A for the connector position of the soft key cable in standalone type
LCD.
4 The screen can be shared in the same way as for the CRT/MDI.
5 For details concerning cable J142 used to connect a Power Mate and
the LCD/MDI or standalone type MDI, see Subsection 8.1.2. See
Section 8.1.3 for how to use the J45 cable for connection with multiple
Power Mate units.
6 For details concerning cable J30 used to connect the power supply to
the LCD/MDI or standalone type MDI, see Subsection 8.1.5.
8.4
LCD/MDI, STAND
ALONE TYPE LCD,
AND STANDALONE
TYPE MDI
INTERFACE
8.4.1
Outline

Leave a Reply

Your email address will not be published. Required fields are marked *