FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

8. CONNECTION TO SETTING AND DISPLAY UNIT
B63173EN/03
256
Device No. *SEL7 *SEL4 *SEL3 *SEL2 *SEL1 *SEL0
#15 ĘĘĘ
#0
#1 Ę
#2 Ę
#3 Ę
#4 Ę
#5 Ę Ę
#6 Ę Ę
#7 ĘĘ
#8 Ę
#9 Ę Ę
#10 Ę Ę
#11 Ę Ę
#12 ĘĘ
#13 ĘĘ Ę
#14 ĘĘ Ę
Common
display Ę ** ***
Recommended cable:
A66L00010284#10P (#28AWG10 ten pairs)
Recommended connector
PCRE20FS or PCRE20FA
Housing PCRV20LA
Maximum cable length : 10m
Relationship between selection
switches and device numbers
: Switch open
Ę : Switch closed
* : Either will do
Recommended cable:
A66L00010284#10P (#28AWG10 ten pairs)
The standalone type LCD is provided with the following adjustment
switch and potentiometers, the factory settings of which must not be
changed. (Adjustment is necessary only when the unit has been
disassembled to replace the adapter or LCD panel.)
VR1 : Flicker adjustment potentiometer
VRP1: Contrast adjustment potentiometer
SW1 : Horizontal position adjustment switch
8.4.4
Adjusting the
StandAlone Type LCD

Leave a Reply

Your email address will not be published. Required fields are marked *